Leaking Tap Repairs Sydney - Fixed Today, Priced Upfront
A leaking kitchen, bathroom, shower, laundry or garden tap? Our licensed plumbers repair it or replace it the same day across Sydney - washer, seat, spindle or a whole new tap - with the price agreed before any work starts.
- $0 call-out fee*No charge just to come and look
- Fixed Price QuotesUpfront pricing before work starts
- Aussie owned & operatedFamily-owned in Sydney since 2010
- Lifetime guaranteeIf our work fails, we fix it
Licensed & insured · Lic #306457C
Get a Free Tap Repair Quote
60 seconds · no obligation
The Leaking Taps We Repair
Find yours below. Whichever tap it is, you get a fixed price before any work starts.
Kitchen Sink Mixers
A dripping spout, a handle gone stiff or loose, or water pooling in the cupboard underneath.
Shower Taps
Taps that keep dripping after you turn them off, or will not close all the way.
Bathroom Basin Taps
Old two-handle taps with worn washers, or a basin mixer that has started to drip.
Garden And Outdoor Taps
Outside taps that will not shut off, leak at the hose fitting, or need replacing.
Isolation Taps
The small taps under sinks and behind toilets, and the ones feeding dishwashers and fridges, replaced when they leak.
Filtered And Boiling Water Taps
Filtered and boiling water taps installed and serviced, and fixed when they start to leak.
Laundry Taps
Leaking washing machine taps, and the hoses that connect to them.
Bath Taps
Dripping bath spouts and wall taps, with worn washers replaced.
Worn Tap Parts
Washers, spindles and mixer cartridges replaced, so the tap you already have stops leaking.
How Bad Is Your Leaking Tap?
Three ways a tap fails. All three end the same way: repaired or replaced in one visit, with the price agreed before we start.
Leaking Or Dripping Tap
A worn washer, seat or O-ring lets water past even when the tap is closed. A slow drip wastes thousands of litres a year, stains the basin and gets worse - we repair it in one visit.
Fixed Before, Leaking Again
A new washer only lasted a few months? The brass seat is pitted or the spindle is worn, so the washer cannot seal. We re-cut the seat and replace the spindle, and the repair holds.
Old, Stiff Or Corroded Tap
Hard to turn, corroded at the base, or a mixer that keeps failing? Replacing it is often cheaper than repeat repairs. We fit your tap or supply one - kitchen, bathroom, laundry or garden.
How We Fix A Leaking Tap For Good
Leaking tap repair Sydney-wide, done properly: find the fault, fix it, and agree the price before we touch anything.
Same-day arrivalFind The Fault
We isolate the water, strip the tap and check the washer, O-rings, seat and spindle. Nearly every leak comes from one of those four, and we show you which one before anything is replaced.
Done in one visitFix It Properly
New washer and O-rings, the brass seat re-cut with a reseating tool, and the spindle or mixer cartridge replaced when it is worn. The common parts are carried on the van, so it is fixed on the first visit.
Fixed price firstOr Replace It
When a tap is past repair, you get an upfront fixed price for a new one, fitted and tested before we leave. Bring your own tap or choose one we carry. Nothing happens without your go-ahead.
Real Sydney Tap Jobs, Fixed In One Visit
Not stock photos. These are our own recent tap jobs, photographed on the tools, with fixed upfront pricing on every one.
Every photo is from the job it sits beside, not a stock library.
Video Testimonials
Stop The Drip. Fix It Once.
Tell us what the tap is doing and a licensed plumber will call you straight back with a time and a fixed price.
- Fixed Price QuotesOnce we have looked at the tap, you get one price for the whole repair or replacement. It holds even when the spindle turns out to be seized or the seat needs re-cutting.
- No Call-Out Fee*Getting a plumber out to look at a leaking tap costs you nothing during business hours. Nothing is charged for the repair until you have said yes to the price.
- Pay Later At 0%Replacing a set of taps or a mixer should not wait for payday. Spread the fixed price over a 0% interest payment plan and stop the drip now.
*Terms and conditions apply.
Get a Free Tap Repair Quote
60 seconds · no obligation
Leaking Tap Repair FAQs
Answer:
It depends on what is worn. A washer and O-ring service on a standard tap is the smallest job we do and is quoted as one fixed price before we start. If the seat needs re-cutting or the spindle or mixer cartridge has to be replaced, the price covers that too, and you approve it before any work begins. There is nothing to pay just for us to come and look during business hours.
Answer:
Sometimes, and if a new washer stops the drip you have saved a call. The catch is that a washer only seals against a smooth brass seat. If the seat is pitted, a new washer lasts a few weeks and the drip returns. A plumber re-cuts the seat with a reseating tool, which is the part of the repair a washer kit cannot do.
Answer:
A pitted or scored seat, a worn spindle, or a jumper valve that no longer sits square. Each of those lets water past a brand new washer. Re-cutting the seat and replacing the worn spindle is what makes the repair hold.
Answer:
Repair when the tap body is sound and only the internals are worn. Replace when the tap is corroded, hard to turn, has failed more than once, or is a mixer whose cartridge is no longer made. We tell you which on the spot and quote both ways when it is a close call.
Answer:
Yes. Most mixer leaks come from the ceramic cartridge, which we replace. Where a cartridge is no longer available for an older mixer, replacing the mixer is usually the better value and we quote it upfront.
Answer:
A single tap is usually done within the hour. A whole house of taps, or a replacement where the old tap is corroded in place, takes longer, and we tell you before we start.
Answer:
Either. We carry standard replacement taps and can supply a mixer or a set of basin taps, or we fit one you have bought. If you are buying your own, check it suits the hole spacing and pressure of your fixture, or send us a photo and we will tell you.
Answer:
Yes. Outdoor taps corrode faster than indoor ones and often leak at the spindle. We replace them with new brass taps, fit a hose connection if you want one, and check the pipe behind the wall while we are there.
Answer:
A tap dripping once a second wastes around 20 litres a day, which is more than 7,000 litres a year on your water bill. A steady trickle wastes far more. It is one of the cheapest plumbing problems to fix and one of the most expensive to ignore.
Recent Tap Jobs Across Sydney
Suburbs where we have repaired or replaced taps recently. Your local team is closer than you think.
Upfront fixed pricing quoted before any work starts. Terms and conditions apply.
